Reducer issue century t900

[welshtroutfisher]

Bought a pair of reducers for the T900s- both reducers fit one rod no issue, the other rod will only accept the reducer about an inch.

Should I potentially sand the reducer to fit the tight rod with some wet and dry or is there another solution?

 

[itchyknackersack]

This also works for the main rod joint any joints that become sticky the correct way is to grease them up when you insert it keep turning it it'll take a while but this creates a grinding paste and will polish joint at same time don't stop turning when you get somewhere near the depth your after give them a good clean you'll notice the places it's touching more that others then start again re grease and keep turning doesn't take that long really ps good exercise for your wrist too lol

 

[Mike hemming]

Give the end of the butt a good clean out first before anything else, don’t do anything drastic, if still problems give century a call , use a carpenter pencil to lub the joints this is also the reducer

 

[stan m]

What`s detailed post 2 above. Don`t go near it with scratch paper.